Installation Guide: Stainless Steel Water Ripple Sheets

Installation Guide: Stainless Steel Water Ripple Sheets

For Ceilings:

1. Base Layer: Fix a plywood base to the ceiling frame.

2. Adhesive: Apply neutral structural glue on the back of the sheet.

3. Mounting: Press the sheet onto the base. Use headless nails in ripple valleys for temporary support.

4. Finishing: Join sheets with T-shaped trim or butt-joint for a seamless mirror effect.

For Walls:

1. Preparation: Ensure the wall is flat and dry.

2. Application: Apply adhesive and double-sided foam tape for instant grip.

3. Alignment: Align the ripple patterns and press firmly.

4. Protection: Remove the protective film only after final cleanup to prevent scratches.